1. The two components are not evenly mixed, and white silk and flower glue appear.

　　The one-way valve of the mixer of the glue dispenser is leaking. Replace the one-way valve.

　　The mixer of the glue dispenser and the channel in the gun are partially blocked, and the mixer and pipeline are cleaned.

　　There is dirt in the proportional pump of the glue dispenser. Clean the proportional pump.

　　The air pressure of the air compressor is insufficient and the air volume is unstable. Adjust the pressure.

　　2. The two-component curing speed is too fast or too slow.

　　The temperature is high in summer, the two-component curing glue will be fast. In winter, the temperature is low, the speed of two-component curing glue will be slower, and the ratio can be adjusted according to the situation.

　　3, two-component glue dispenser press plate to take glue

　　The pressure plate sealing ring is damaged, deformed, aging, hardened, and replaced with a new rubber ring.

　　②The lifting pressure is too large.

　　The barrel is too big to fit. At the time of purchase, the customer first measures the size of the pressure plate of their glue dispenser. There are currently three models of machine platen on the market, 560mm, 565mm, and 571mm, which can be packed in barrels according to the size of the customer’s machine platen.

　　4, the plastic tray can't be pressed down

　　The barrel is deformed and not round. The mouth of the barrel can be crushed with a hammer and then pressed down.

　　If the barrel is too small or the pressure plate sealing ring is too large, you can apply a little white glue on the sealing ring for lubrication, and then press it down.

　　5, two-component bubble problem

　　The air cannot be completely evacuated during gluing, so every time the glue is changed, the valve to drain the air must be opened, and then opened after the air is drained.

　　Air is mixed during manual glue mixing.

　　6. ​​The problem of fogging when insulating glass is installed through the exchange of heat and cold.

　　Two-component silicone rubber is mainly a two-way seal, which plays a role in structural adjustment. Therefore, the first seal must be sealed with butyl sealant, and the insertion angle must be sealed with butyl sealant.

　　In the hot and humid season, good quality molecular sieves must be used to completely clean the remaining moisture after the glass is sealed, so as not to cause trouble. The entire operation time cannot be too long.

　　Our company mainly deals in two-component, sealant, glass glue, structural glue, weatherproof glue, silicone glue and other products. Welcome to contact us.